AgOpenGPS
  • 🚜START HERE
  • 🤓Starters Guide
    • What to buy
      • TL;DR - cut to the chase, what do I BUY???
      • Choosing and ordering a board - standard or micro?
      • GPS modules - standard or micro?
      • Choosing an antenna
      • Connectors
      • Teensy 4.1
      • Cytron motor driver
      • Wheel Angle Sensor
      • IMU (inertial measurement unit)
      • Miscellaneous
      • Tablet
      • The motor
      • Motor? Nah - hydraulic please!
      • Motor/hyd? Nah.. CANbus please!
      • Other guides and resources
  • 💪Putting it all together
    • Assembling the board
      • Components you can do without
      • Electrical testing and validation
    • Configuring the ZED-F9P
    • Configuring the Teensy
    • Configuring your tablet
      • Downloading the software
      • Connecting tablet to board
  • 🤩AgOpenGPS - a guide for machine-users
    • aka "the manual"
  • 🤯Frequently Asked Questions
    • Frequently Asked Questions
      • Help! I need to speak to someone!
      • Placeholder for FAQ categories
      • AGIO
        • UDP
        • RTK/NTRIP corrections
        • Serial/COM ports
        • AgIO and AgOpenGPS - networking
      • AgOpenGPS
        • Is AGIO running? AgIO?
      • U-blox F9P
        • Firmware and configuration fails
        • VTG?
        • Baud rates?
        • U-Center?
      • Teensy 4.1
        • Swapping GPS ports
      • PCB
        • PCBv2
        • PANDA
          • $PANDA ?
          • $PAOGI ?
        • All-in-one boards
          • Standard board
          • Micro board
  • 🤬Problems and Solutions
    • Problems and Solutions
      • U-Center can't update the F9P firmware
Powered by GitBook
On this page

Was this helpful?

  1. Putting it all together
  2. Assembling the board

Components you can do without

TODO: If you're not going CANbus, you can do without these.

PreviousAssembling the boardNextElectrical testing and validation

Last updated 2 years ago

Was this helpful?

💪