AgOpenGPS
  • 🚜START HERE
  • 🤓Starters Guide
    • What to buy
      • TL;DR - cut to the chase, what do I BUY???
      • Choosing and ordering a board - standard or micro?
      • GPS modules - standard or micro?
      • Choosing an antenna
      • Connectors
      • Teensy 4.1
      • Cytron motor driver
      • Wheel Angle Sensor
      • IMU (inertial measurement unit)
      • Miscellaneous
      • Tablet
      • The motor
      • Motor? Nah - hydraulic please!
      • Motor/hyd? Nah.. CANbus please!
      • Other guides and resources
  • 💪Putting it all together
    • Assembling the board
      • Components you can do without
      • Electrical testing and validation
    • Configuring the ZED-F9P
    • Configuring the Teensy
    • Configuring your tablet
      • Downloading the software
      • Connecting tablet to board
  • 🤩AgOpenGPS - a guide for machine-users
    • aka "the manual"
  • 🤯Frequently Asked Questions
    • Frequently Asked Questions
      • Help! I need to speak to someone!
      • Placeholder for FAQ categories
      • AGIO
        • UDP
        • RTK/NTRIP corrections
        • Serial/COM ports
        • AgIO and AgOpenGPS - networking
      • AgOpenGPS
        • Is AGIO running? AgIO?
      • U-blox F9P
        • Firmware and configuration fails
        • VTG?
        • Baud rates?
        • U-Center?
      • Teensy 4.1
        • Swapping GPS ports
      • PCB
        • PCBv2
        • PANDA
          • $PANDA ?
          • $PAOGI ?
        • All-in-one boards
          • Standard board
          • Micro board
  • 🤬Problems and Solutions
    • Problems and Solutions
      • U-Center can't update the F9P firmware
Powered by GitBook
On this page

Was this helpful?

  1. Putting it all together
  2. Assembling the board

Electrical testing and validation

PreviousComponents you can do withoutNextConfiguring the ZED-F9P

Last updated 2 years ago

TODO more info on this, but here is a great guide on how to test your PCB before blowing anything expensive up:

💪
LogoAll in One PCBAgOpenGPS